How to replace linings in the amalgamator

Ha the bottom end there is kranovaja a sealing lining from rubber, pressure upon a lining and minerals containing in water leave appreciable traces: strong deformation and adjournment to exhaust do a lining unreliable. After untwisting of the safety screw or a safety nut it is possible to replace a rubber lining.

During this repair it is necessary to check the gate case. On its appearance and to the touch it is possible to understand, whether it has an equal surface. If it is necessary, milling of the case of the gate eliminates adjournment and corrosion traces. Enough two-three turns, differently will be removed bolshy a layer, than it is necessary.

At armature with rotary slivom from time to time happens that at an open crane-axle box water acts on the flat hinge. Here it is necessary to turn off the chromeplated safety nut then it is possible to remove rotary having merged. New sealing rings are rubbed before installation armaturnoj greasing. This special greasing does not cause doubts that is not injurious to health, and protects sealing rings from too fast deterioration.

Ceramic washers-linings of one-lever amalgamators have long service life. If drips from the crane it is possible reusable opening and closing by jerks to wash off the dirt which has accumulated on washers-linings. If and after that still drips, amalgamator dismantling is necessary.

Councils about business:

At modern one-lever amalgamators after untwisting of the safety screw it is possible to remove movement upwards the handle of adjustment of giving of pressure of cold and hot water.

Depending on a design at repair of the one-lever amalgamator it is necessary to replace all uplotniteli and to replace the amalgamator.

After long using the water crane once there is a such: zapornyj the gate is not closed. To prevent such breakages seldom used zapornye gates should move regularly – at least time in a year.