Box for tools

In a box shown on a photo, it is easy to transfer tools and they are convenient for using. It is possible to store in long branches ножовки and even small electrotools. In grooves and apertures in crosspieces and the central partition small tools will conveniently take place also.

Walls and box partitions can be made of any firm dovesiny, for example, a maple or an oak, a bottom — from plywood in the thickness of 12 mm or boards.

Begin manufacturing of a box with cutting out of lateral walls And, partitions In and With and bottom D. Boards should be straight lines and without knots. If it is necessary, prostrugivayut lateral walls and partitions, but a thickness of the central partition should be such that in its end face it was possible to drill apertures in diameter of 12 mm.

From a wide strong board cut E.Tak kak's face walls on them it is necessary all weight of a box, choose strong wood with a dense fibre without cracks and signs коробления. Edges of the cut walls round a plane, a rasp and sander.

In lateral and face walls at height of 6 mm from the bottom edges choose grooves in width of 12 mm and depth of 6 mm. That grooves were not visible, finish them, without reaching 12 mm the ends of details.

The handle of 57 mm, prostrogannoy till the thickness do of preparation of wood in width of 32 mm. At first on tsirkulnoy to a saw cutshoulders  thorns. At height the length and a thickness of thorns makes of 32 mm 20 mm, and width заплечика should be equal 6 mm. As the handle has the a bit curved form, has washed down for shoulder do on distance of 20 mm from the top edge of preparation.

After запилы will be made, a sharp chisel delete superfluous wood. Then mark the handle (its height - 32 mm) and cut a fret saw or a tape saw. A mill with R=10 or R=12 mm (or a rasp and even a rough skin) round handle edges.

On thorns on the handle check the size of grooves in face walls. Then in the marked grooves drill apertures in diameter of 20 mm and a chisel give them a squared shape. Not to chop off wood, accurately drill an aperture from both parties of a detail, and as a chisel work from groove borders to the middle.

In the top edge of the central partition drill apertures in diameter of 12 mm, mark its position at the bottom of a box and from a bottom of 32 mm fix this partition several screws the in length. The second partition fix similarly. Cut crosspieces G — holders of tools. On tsirkulnoy to a saw or the milling machine on the ends of crosspieces choose quarters under lateral walls, and in the middle — a groove for the central partition. Crosspieces to a box glue and finishing nails the in length of 40 mm fix.

Box smooth out a skin and cover with drying oil or wax mastic.