Rules of operation of the clutches and care

It would seem, may be to maintaining a vice? Because this tool at first glance, does not require absolutely not in any service. But no, and vice should be cared for no less than other tools. You also need to know how to exploit them. To learn how to do it and will be discussed below. 1. Before each use, check the clutches of their attachment to a desk or workbench, if any, vise. 2. Caught in the grip of parts can be made ​​only by hand specially designed for the arm or the petals of a lamb. Blows on the handle, the handle unacceptable build-up to avoid damaging the screw threads and nuts. 3. Removable steel plate clutches have to be so hardened that barely scratching their file. When the extent of quenching in bars remain a certain amount of viscosity, and they will not crumble. 4. The lead screw to rotate the nut smoothly and without much friction. To do this, his smeared grease any grease, petroleum jelly, grease, or a mixture of melted stearin (the candle), powdered graphite (pencil on the rod) and engine oil. Sam spindle grease preferably unscrew. 5. Impact tools (hammers, sledge hammers) and the nature of the work necessary commensurate with the size and destination of the grip. This is especially true cutting chisel, bending parts, etc. 6. All parts of the vices, firmly connected with the manufacture and assembly, must maintain this state. 7. When compressing shells sponges removable slats should contact length and vertical planes. If this is not happening because of the barbaric attitude to the grip, then one way to remedy the defect - the removal of a layer with strips or planks. 8. In between using the grip body sponge should be possible to dissolve in the presence of a spring between them. Even in the absence of springs gap between the buildings and their replacement sponge strips eliminate tension in the spindle and the nut. 9. When you install the grip they need to be outdoors to paint, brush and cover.